| Please read all directions in
each stencil package before beginning.
The following instructions are for the Pergola painted as
part of the Garden Delight Mural. The listed dimensions may
be changed to accommodate your own wall space. We recommend
that you trace the design on a large piece of paper so that
you become comfortable with the assembly process. You should
also try painting a small portion on paper to get the feel
for how much paint to put on your roller so that it does not
seep under the edges of the stencil.
Once you decide where you are going to put the design, you
need to make some measurements and then you can start painting. |
| Step 1. Measure 7 ½
inches down from the ceiling or molding. Mark this measurement
a few times on the wall so you can draw a straight horizontal
line. |
|
| Step 2. Measure 32" from left to
right, put a mark at 0" and again at 32". Do this
a couple of times down the wall.
Step 3. Connect the dots you marked on the wall in
a straight vertical line. (From ceiling to floor) Do this
on both the left side and the right side.
|
|
| Step 4. Using Sheet 1 stencil piece #10
hold it so you can read the SE D413. Line the right side of
the #10 rectangle so it lines up with the outside of the left
line, and the top of the piece is aligned with the horizontal
line you drew from the ceiling. Tape to wall and lightly mark
the top two triangle registration marks (TRMS). Take off wall
and do the same thing on the right hand side. Remember to go
to the out side of the line you drew. |
|
| From here on
out we will be using the stencils in order from #1 - #11.
|
| Step 5. Next Take stencil sheet 1 which
has #1 start on the left hand side line the two BOTTOM TRMS
up with the two you have already marked on the wall. Tape this
piece to the wall. Then lightly mark all the other TRMS for
piece #1. (These will be needed for other parts) |
|
| |
