| 
Click
to order Let It Snow! stencil
|
SUPPLIES NEEDED:
- Wooden Plate - approx.
11 1/2 diameter (29.21cm)
- White latex paint
- small paint brush
(1", 2.54cm) or foam paint applicator
- SMH003 Snowflake
Snowman Stencils
- SMH004 Let It Snow
Stencils
- Spill Proof® Stencil Paint in the following colors:
MSP01046 Royal Blue
MSP0100 Metallic Silver
- stencil brushes
*NOTE: If you are planning on using this plate to
serve food, you should purchase a clear glass plate as
a liner. It is not recommended that food come in direct
contact with paint. |
| Paint wooden plate with white latex paint and
allow to dry. Stencil snowflakes all over the plate Using the
MH-4 Let It Snow Stencil and SP-100 Metallic Silver stencil
paint. Allow to dry overnight. Center the MH-3 Snowflake Snowman Stencil on the
plate and stencil with SP-46 Royal Blue. |
There are two ways you can stencil the words on
the plate:
1 - stencil one letter at a time, repositionaing the stencil
for each letter. This will keep the stencil in one piece and
ready to use again. You may want to cut out a paper circle 7"
in diameter to use as a guide for placing the lettering. Place
the guide in the center of the plate and line up the bottom
edges of the letters with the paper edge. |
2 - Cut the stencil apart as shown. The letters
are not quite cut all the way apart so they can be fanned out.
Tape in place on the plate to stencil all of the words at one
time. |
